The Right Tool

At the end of my last post all that was standing between me an the removal of the axle shaft was a rather large circlip. I had probably wasted about 45 minutes trying to extract it using a cheap set of circlip pliers. I am now the proud owner of  a better pair of circlip pliers - namely the Knipex 44 11 J3 (pictured below).

 It turns out these were the right tool for the job. Extracting the problematic circlip took all of fifteen seconds (and ten of those were spent getting myself into the correct position). Here is the the proof...

Next time I'll be reporting on whether or not the axle shaft could be machined for a reasonable amount of money or whether I needed to splash out for a new one.